Renovation of Burner For Asphalt Plant

We all know that the burner for asphalt plant is one of the key component of asphalt mixing equipment line. Thus the burner quality is very important to ensure the aggregate and asphalt temperature and save energy. As the asphalt mixing plant equipment used was purchased earlier, its burner and drying system can only meet the requirements of diesel combustion, but as the price of diesel increases, the economic efficiency of the asphalt mixing plant equipment is getting lower and lower. In this regard, the user hopes that it can be solved through the transformation of the burner system of the asphalt mixing equipment.

The transformation of the burner for asphalt plant equipment mainly includes these aspects. The first is the replacement of the burner device. The original diesel burner spray gun is replaced with a heavy and diesel dual-purpose spray gun. This kind of burner device is relatively short and does not need to wind the electric heating wire. The most important thing is that it will not be blocked by the remaining heavy oil, so that the heavy oil can be fully burned and the consumption of the heavy oil is reduced.

The second is to transform the previous diesel tank and lay a heat-conducting oil coil at the bottom of the tank so that it can be used to heat the heavy oil to the required temperature. At the same time, a separate electric control cabinet must be set up for the entire burner system of asphalt mixing plant to realize automatic switching between diesel and heavy oil, and the system will be protected with sound and light alarms.

Another part is the improvement of the heat-conducting oil furnace, because the heat-conducting oil furnace that burns diesel oil was originally used. This time, replacing burner for asphalt plant with a coal-fired heat-conducting oil furnace can greatly save costs.