Temperature Controller - Asphalt Station

Temperature Controller - Asphalt Station

UDC3300 temperature controller debugging methods and procedures:

1. Press SETUP key to display temperature controller SETUP TUNING, then press FUNCTON key when the following parameters were:

A. PROPBD: 15 Self-adjusting range

B. RATE MIN 0.02 change in indexing / min (0.00 to be invalid)

C. REST PRM 1 to reset the number of minutes

D. SECURITY 0 This is a setup password (110)

2. Press the temperature controller SETUP key until SETUP INPUT 1, then press the FUNCTION button to enter, adjust the following parameters

a: IN 1 TYPE J TC L thermometer choice for the original J thermocouple,; 4-20MA, infrared input

b: according to the temperature controller LOWER DISPLAY key to exit.

3. Press the temperature controller SETUP key until SETUP ALARMS, then press the FUNCTION button to enter, adjust the following parameters

a: A1S1 VALUE 160 alarm temperature settings, this setting should be based on the temperature requirements of dust bag set their own, generally 160 ºC - 200 ºC.

b: according to the temperature controller LOWER DISPLAY key to exit.

4. Press the temperature controller SETUP key until SETUP DISPLAY, then press the FUNCTION button to enter, adjust the following parameters

a: TEMPUNIT: DEG C Fahrenheit turn Celsius, F ?? changes to ºC

b: PWR FREQ 50HZ power frequency, 60Hz ?? changed to 50Hz

c: by temperature controller LOWER DISPLAY key to exit.

5. Automatic calibration oil throttle servo motors.

A. does not start burner.

B. The foot-powered control box LEC111 number, according to the temperature controller SETUP key until CALIB POSITION appears.

C. Press the FUNCTION button twice to display after DISABL POS PROP Press button until DO AUTO.

D. Press the FUNCTION button to display after ZEROVAL and numbers, change the value from large to small, the value is not fixed either the zero position is completed. So when the motor is in the zero position, the value unchanged. After completing figure should be around 660.

E. Press the FUNCTION button to display SPANVAL and digital, from small to large changes in value, fixed value after the completion of both the maximum flame position. At this figure should be around about 3300.

F. Press the FUNCTION button to complete the calibration procedure, according to the temperature controller LOWER DISPLAY key to exit.

G. Repeat the steps in the process, repeated several times, complete temperature control servo motor calibration procedure. Note: The above process, please be sure to send on-site inspection servo motor connecting rod during the rotation is flexible, otherwise immediately turn off the controller power to prevent the death of the servo Ma Daka burned.